- 123 -
EO3-11070
MA-1650-4 SERIES
Report Report Name Mode for output
Code
3 Financial ****
4 All Individual Cashier ****
5 All Salesperson **
6 Credit Card Company Sales (All Indiv. Companies) ****
8 Department Group **
9 Each Media Sales and In-drawer Total *
10 Hourly Range **
11 All Department ****
12 All Media Sales and Cash-in-drawer *
13 All PLU Sales ****
15 All Customer File *
24 PLU Group ****
X Z GTX GTZ
*: output
Blank: no output
Report Code Table
NOTES: 1. In report takings using a Combination Report Table, only those marked with “*” (output) will be
outputted of all the contained reports in accordance with the mode set at that time.
Example: When Reports 8 (Department Group), 10 (Hourly Range), and 11 (All Department)
are programmed in a table:
Reports outputted in each mode
X: Department Group, Hourly Range, All Department
Z: Hourly Range, All Department
GTX: Department Group, All Department
GTZ: All Department
2. For designating each Combination Report Table in report takings in X or Z mode, operate as in
the table below:
Combination Report Daily Reports GT Reports
Table Output (Read or Reset) (Read or Reset)
Table 1 [AT/TL] 200 [AT/TL]
Table 2 1 [AT/TL] 201 [AT/TL]
Table 3 2 [AT/TL] 202 [AT/TL]
3. When changes are made on report combination in a table, entirely or partially, program all the
reports in that table again.
4. An error will result if a Report Code that has already been entered is attempted to enter again in
the same table.
5. In Table No.1, auto-preset report combination of Report 11 (All Depts) and Report 3 (Financial)
is programmed. It will be active as Table No.1 content unless no data are programmed for Table
No.1.
To Next Page
Loading...
