- 136 -
EO3-11070
MA-1650-4 SERIES
PLU PRESET-CODE KEY SETTING (Submode 27)
When there are any keys programmed as PLU Preset-code Keys (SFKC 96) on the ECR Keyboard (Ordinary or
Flat Type), and/or when the PLU Keyboard PK-2 (hardware option) is connected to the ECR, a PLU code may
be preset to each of those keys in this operation.
CONDITION Any time outside a sale
OPERATION Mode Lock: SET
Barcode Scanning
27 [X] |PLU Code| [KEY] [AT/TL]
ex.) To set the following:
Tare Table No. 1 with Tare Weight 0.13 LB,
General Weight 2 LB (Code 2).
Mode Lock: SET, 26 [X]
1 [ST] 13 [#] 2 [AT/TL]
TEC STORE
1343 PEACH DRIVE
PHONE: 87-6437
Open 8:00am to 7:00pm
Closed: every Wednesday
11-14-1994 MON #1
P26
#1 0.13LB
2LB
0037
Repeat for other keys.
➤
➤
➤
➤
➤
Enter through
Numeric Keys on
the ECR Keyboard
(Enter 0 to close the
key); Max. 6 digits
Depress the required key
on the ECR Keyboard or
on the PK-2 Keyboard.
NOTES: 1. If the PLU Code entry is skipped and a [KEY] is simply depressed in the above sequence, the
preprogrammed PLU Code of the KEY will be displayed.
2. A non-opened PLU Code (i.e. PLU non-existent in the PLU table file) can be set on a KEY;
however, pressing the KEY in sale entries will result in an error unless the code is opened in the
PLU TABLE PROGRAMMING operation, Submode 4.
3. If “0” is entered as PLU Code in the above sequence, the KEY will be closed. Pressing the closed
KEY in sale entry will cause an error.
To Next Page
Loading...
