- 83 -
EO3-11070
MA-1650-4 SERIES
NOTES 1. “Net to S.I. 1, 2”
Refer to the section “PRESET RATE SETTING FOR SELEC-
TIVE ITEMIZERS” near the end of this chapter.
2. Tax symbol “F” is printed when this status code has been set “ON” to a
taxable department.
• If the GST feature has been selected, this symbol “F” will be always
printed regardless of this code status when a GST taxable department
is entered.
• If the Food Stamp feature has been selected, this symbol “F” will be
always printed regardless of this code status when a food stamp
taxable department is entered.
* In Canada, some area handles two kinds of tax; GST and PST. Status
Code 4 (Tax Print “F” Print) should be set when the GST status has
been selected in the Status 1 Selection on the preceding page.
Tax Symbol “T” ...... PST
Tax Symbol “F” ...... GST
3. When the Age Limit 1 or Age Limit 2 Status is set to ON, the age
confirmation is always necessary before entering a sales item. Neither
Status Code 6 (Age Limit 2 Status) nor Status Code 7 (Age Limit 1 Status)
can be combined with Status Code 5 on the Status 1 selection (Scale
Allowed).
4. On the application, the Age Limit 1 Status is applied to a sales item with
the age limit younger than that of the Age Limit 2 Status.
-- Continued on next page --
Status Item Selective Status
Code OFF ON
1 Net to S.I. 1? No Yes
2 Net to S.I. 2? No Yes
3 Tare 3 Entry Optional Compulsory
4 Tax Symbol “F” Print Non-print Print
(Applicable for V1.9 or after)
5 Canada Non-taxable Quantity Not objective Objective
(Applicable for V1.9 or after)
6 Age Limit 2 Status Unnecessary Necessary
(Applicable for V2.0 or after) (Age confirmation) (Age confirmation)
7 Age Limit 1 Status Unnecessary Necessary
(Applicable for V2.0 or after) (Age confirmation) (Age confirmation)
Address No. Description of Programming Contents
-- Continued --
Setting Examples:
To set only Status 2 to ON .............. Enter 2 [#]
To set Statuses 2, 3, 5 to ON .......... Enter 235 [#]
To set none of statuses to ON ........ Enter 0 [#]
5 Status 2 Selection
• Enter Status Codes 1 to 7 whose status must be set to ON side.
To Next Page
Loading...
