3. DIAGNOSTIC TEST OPERATION EO18-11006A
3.2 Print Test (“H” & All Characters)
3- 2
3.2 Print Test (“H” & All Characters)
(1) Contents
A print test is performed. This test prints “H”s and all characters.
(2) Operation
Mode Lock: BLIND
Key Operation: 80 [X] (or [@/FOR]) 1 [AT/TL]
(3) Print Format
(4) Display
No function
(5) Quit
The test ends by pressing the [ITEM CORR] key.
NOTES:
1. In the Receipt OFF mode, the print data is printed only on the journal.
2. When the power is turned OFF during the test, it will be resumed at the power on time unless the Mode Lock
position is “BLIND”.
3. When the paper is set on the remote slip printer, the test is also performed on this printer.
10-31-2005 MON #0
P80
DIAG 01
HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH
:
HHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHH
HHHHHHHHHHHHHHHH
:
HHHHHHHHHHHHHHHH
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰‰
################################
:
DDDDDDDDDDDDDDDDDDDDDDDDDDDDDDDD
0004 15:40TM
One-byte “H”s are printed consecutively.
(32 characters by 10 lines)
Two-byte “H”s are printed consecutively.
(16 characters by 10 lines)
Each character codes are printed by line.
(32 characters/line)
Store Name Logo
To Next Page
Loading...
Need help?
General
