tecan HYDROFLEX PLUS - Operating Instructions; Performing a Wash Procedure

4. Operating Instructions
2022-01 HYDROFLEX PLUS No. 30199906 Rev. No. 1.1 33
4.3 Operating Instructions
4.3.1 Performing a Wash Procedure
Insert the 96-well microplate to be washed into the plate transport and ensure
that the microplate is correctly oriented (position A1 of the plate corresponds to
position A1 marked on the plate transport).
Fig. 4.1 Fitting a microplate
The operating procedure is dependent on the instrument options and the program
settings.
CAUTION
BEFORE WASHING PROCEDURES ARE STARTED, MAKE SURE THAT
THE MICROPLATE POSITION A1 IS INSERTED CORRECTLY.
CAUTION
BE CAREFUL WHEN USING STRIP-PLATES THAT THE STRIPS ARE
POSITIONED IN THE MICROPLATE AS SELECTED IN THE PROGRAM,
OTHERWISE SPILLING CAN OCCUR AND THE INSTRUMENT MAY
BECOME CONTAMINATED (SEE 5.2.2 DEFINE/EDIT A PROGRAM
(DEFINE/EDIT MENU)).
WARNING
WHEN THE INSTRUMENT IS BUSY, DO NOT TOUCH THE MANIFOLD!
AFTER THE INSTRUMENT HAS BEEN USED,
THE MANIFOLD AND PRIME TRAY MAY BE INFECTIOUS!