Need help?Do you have a question about the Technica MediaGateway and is the answer not in the manual?
Overview of the MediaGateway's capabilities, including connectivity and supported protocols.
Provides technical specifications like voltage, power consumption, size, weight, IP rating, and operating temperature.
Outlines operating conditions and safety guidelines for automotive system products.
Covers important safety advice, usage instructions, and product intended use.
Presents the official RoHS certificate for the MediaGateway.
Lists the items included in the MediaGateway package and how to order more.
Introduces the hardware interfaces and provides an overview from the device label.
Details the black MQS connector, its parts, and pin assignment for power and control signals.
Describes the blue MQS connectors, pin assignments for camera output and 100BASE-T1 ports.
Explains RJ-45 Ethernet, SFP slot, and Micro HDMI connectors.
Describes status LEDs and the function of the reset button for factory default settings.
Guides users on how to connect to the MediaGateway's webserver interface via an RJ-45 port.
Explains saving changes and viewing system information like firmware and MAC address.
Details the Control Panel for device management and feature activation using keys.
Introduces Switch Status tab for port configuration and Global Configuration for VLAN modes.
Describes viewing Address Resolution Table (ARL) entries for switches, including dynamic and static modes.
Details configurations for ports when no VLAN tagging is enabled, covering RJ-45, SFP, and 100BASE-T1 ports.
Details configurations for ports when single VLAN tagging is enabled, covering RJ-45, SFP, and 100BASE-T1 ports.
Details configurations for ports when double VLAN tagging is enabled, covering RJ-45, SFP, and 100BASE-T1 ports.
Outlines crucial rules for VLAN tagging, including default VLAN ID, membership, and egress VID remarking.
Introduces CAN Gateway functionality and covers UDP, Raw, Speed RAW, and Extreme RAW modes.
Details the structure of CAN packets within UDP and RAW Ethernet frames.
Provides a step-by-step guide for configuring the MediaGateway to log communication between two devices.
Guides on configuring the MediaGateway to allow third-party access for data injection.
Explains how MediaGateway acts as a time-aware system bridge for time synchronization.
Explains the measurement of propagation delay using Pdelay messages and a formula.
Describes 802.1AS bridge configuration, port roles, and operational limitations.
Describes the Board Configuration Frame payload containing device and port information.
Describes the Port Information Frame payload, containing port status and bitrate details.
Lists implemented SOME/IP methods for remote control of the MediaGateway.
Details SOME/IP methods for device reset, import, export, and dynamic configuration.
Explains SOME/IP methods to check status, set, and get wakeup line information.
Details SOME/IP methods for enabling/disabling ports and setting master/slave modes.
Explains the SOME/IP method to retrieve system information and active licenses.
Lists warnings and notes for firmware updates, including prerequisites and precautions.
Provides step-by-step instructions for performing the firmware update process.
Troubleshooting guide for LED errors, webserver access problems, and host LED blinking.
Covers packet delay, AVB support status, maximum frame size, and website interface issues.
To Next Page
General