MediaGateway User Manual
Default: You can reset the configuration settings to default. All values will be set to
default except the IP address. It will be not modified.
Enable camera power: The camera power output pins are disabled by default. To
activate them, this checkbox should be checked.
Prevent sleep: If you do not want to use a Wakeup line, you can enable the “Prevent
sleep” checkbox (default). This will keep the device running without entering the sleep
mode. If this option is disabled, the device will go to sleep if no activity is recognized
according to observed ports. (Please see the configuration of each port in CHAPTER
3.6)
Diagnose service: If you enable this functionality, the MediaGateway will send
periodically status information about its state. For example, transmitted and dropped
frame counters, link quality, etc. For more details please see CHAPTER 6
3.4.2 MediaGateway Feature Activation
MediaGateway features and Activation key:
CAN Gateway
FlexRay Gateway
BMW Extra Functions (not available)
For activation of the extra features (CAN Gateway, FlexRay Gateway) an activation key
is needed. Please contact order@technica-engineering.de if you want to order an
activation key. Or contact technicalsales@technica-engineering.de for more
information about the conditions of these features.
For the activation key please write an Email to support@technica-engineering.de with
following information:
Order number
UUID of the MediaGateway
Ordered Feature
To Next Page
Loading...
General