MediaGateway User Manual
- The frame will be sent from Switch 1 to Switch 2 without outerVLAN tag,
because the frame had no outerVLAN tag while entering the Switch 1
Note: Please be aware, that the internal ports P4/P8 between the switches must be
handled the same as all other ports. That means: if you want to send data from one
switch to the other, you have to be aware about the egress VID remarking, especially
for the outerVLAN tag if you need this tag in the next switch!
If frames leave on S1-P8 the switch, VLAN tags will be removed or not, dependent
from the configuration of the egress VID remarking. They enter on S2-P4 the next
switch and will be tagged following the tagging rules for incoming traffic
3.7 CAN Gateway
Note: The CAN Gateway is in the Microcontroller (CPU). The Switch 1 has to be
configured in a way that the microcontroller has still a connection to your PC.
Note: The CAN Gateway is not able to work with CAN-FD.
To Next Page
Loading...
General