MediaGateway User Manual
8.2 Update
1. Power up the device
2. Reset the MediaGateway to default settings: IP must be 192.168.0.49
3. Make sure the network adapter from your PC is configured in the same IP range
(e.g. 192.168.0.60)
4. Connect the network-adapter with a RJ-45 cable directly to the Port S1-P5 and
make sure there is a link by checking the LEDs blinking. Do not connect a switch
in between.
5. Start “update_all.bat” from the same folder as the firmware files are stored.
6. Wait until “Press any key...“appears in cmd-window.
7. Press any key
8. Do a power reset
9. Check the Host-LED if it is blinking in normal mode.
10. YES => check webserver by browser
NO => redo from point 5.
=> Finished
To Next Page
Loading...