MediaGateway User Manual
3.7.6.3 Structure of Payload from the UDP or RAW ethernet frame ............. 74
4 Configuration Examples .......................................................................................... 76
4.1 Logging communication between two DUTs .................................................. 76
4.2 Get access by third communication partner ................................................... 79
5 PTP AND 802.1AS in the MediaGateway ............................................................... 81
5.1 Protocol ............................................................................................................. 81
5.2 Transport of time-synchronization information .............................................. 81
5.3 Propagation delay measurement ..................................................................... 83
5.4 802.1AS in the MediaGateway ......................................................................... 84
5.5 Limitations in MediaGateway using 802.1AS .................................................. 84
6 Diagnostic Frames .................................................................................................. 85
6.1 Board Configuration Frame (0x8001) .............................................................. 85
6.2 Port Information Frame (0x8002) .................................................................... 89
7 MediaGateway Remote Control .............................................................................. 91
7.1 Reset Device ...................................................................................................... 92
7.2 Import Configuration......................................................................................... 92
7.3 Export Configuration ......................................................................................... 93
7.4 Dynamic Configuration ..................................................................................... 93
7.5 Check Status ..................................................................................................... 94
7.6 Set WakeUp Line Status ................................................................................... 94
7.7 Get WakeUp Line Status ................................................................................... 95
7.8 Set Port Enabled/Disabled (only 100BASE-T1-Ports) ..................................... 95
7.9 Set Port to Master/Slave (only 100BASE-T1-Ports) ........................................ 96
7.10 Reset to default ............................................................................................. 97
7.11 Get System Information ................................................................................ 97
8 APPLICATION AND FIRMWARE UPDATE .............................................................. 99
8.1 Preconditions and important information ....................................................... 99
8.2 Update ............................................................................................................. 100
9 TROUBLESHOOTING AND FAQ ............................................................................ 101
9.1 All 100BASE-T1 LEDs are lit permanently ...................................................... 101
9.2 Four 100BASE-T1 LEDs of one Switch are lit permanently ........................... 101
To Next Page
Loading...
General