MediaGateway User Manual
Port name: Here you can change the Port Name
Default VLAN ID (hex): please define one hexadecimal value between 0x1 and 0xFFF.
Incoming traffic is tagged with this value, if NOT already tagged. It is NOT overwriting
VLAN-IDs. This rule is valid for innerVLAN and outerVLAN!
VLAN membership: as many as wished values between 0x1 and 0xFFF can be defined
here separated by “,” [E.g.: 100, 101, EDF, …]. Outgoing traffic can leave the switch on
this port, if the data is tagged with one of the defined VLAN-IDs. Only outerVLANs are
checked!
Egress VID remarking: this must be defined for innerVLAN and outerVLAN separately.
This adjustment is valid only for (allowed) outgoing traffic. Three different options are
available:
As received: a frame came in to the (current) switch on another port. This frame
must leave on this port “as received” =>
o leave with VLAN if received with VLAN on another port
o leave without VLAN if received without VLAN on another port
Remove: a frame leaves the switch on this port without the VLAN
Normalized: a frame leaves the switch on this port with the VLAN
Tx octets: decimal value of sent octets on this port.
Rx octets: decimal value of received octets on this port.
Prevent Sleep Port: This option is available if the function “Prevent sleep” on “Control
panel” tab is deactivated.
This port is monitored: If there is incoming traffic on this port, the
MediaGateway doesn’t fall asleep.
This port is not monitored: The MediaGateway can fall asleep, even if there is
incoming traffic on this port.
Mirroring: On each switch only on port can be a mirroring port. Please select the ports
to be mirrored
SFP option: The correct SFP Module option has to be chosen, as
long as there is any SFP Module plugged in.
Fiber module: please select this option for fiber optical
SFP-modules.
RJ45 module: please select this option for copper modules.
To Next Page
Loading...