16
2 Setting up your DWA0120
DMS3-CTC-25-552 v1.0
2.2 Powering on your DWA0120
Procedure
Proceed as follows:
1 Plug the connector of the power supply unit into your DWA0120 power inlet port ( ).
2 Plug the power supply unit into a nearby power outlet.
3 Press the power button to turn on your DWA0120.
4 The LED turns on. Wait at least two minutes to allow your DWA0120 to complete the startup phase.
Only use the power supply unit that is supplied with this product, is supplied by your service provider or local product
dealer, or a replacement power supply unit provided by your service provider or local product dealer.
The use of other types of supplies is prohibited.
If you are not sure of the type of power supply needed, consult the product's user documentation or contact your
service provider or local product dealer.
To Next Page
Loading...
