31
3 Wireless networking
DMS3-CTC-25-226 v1.0. Copyright © 2016 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
3.4.2 Configuring WPA-Enterprise encryption
Requirements
A RADIUS server must be readily set up on your local network.
Procedure
Proceed as follows:
1 Browse to the TG589vac web interface.
For more information, see “4.1.1 Accessing the TG589vac web interface from your local network” on page 34.
2 Click Wireless. The Wireless page appears.
3 On the left menu, select the access point that you want to configure.
4 In the Security Mode list under Access Point, select one of the following modes:
WPA2
WPA+WPA2
For more information, see “Encryption types” on page 29.
5 The following RADIUS settings are now available for configuration:
RADIUS Authentication Server's IP: enter the IP address of your RADIUS server.
RADIUS Authentication Server's port: enter the WPA RADIUS Port.
RADIUS Authentication Server's secret: enter the WPA RADIUS Key.
6 Click Save to apply your changes.
7 Reconnect your wireless client(s) to your TG589vac.
For more information, see “3.2 How to manually connect a wireless client” on page 27.
To Next Page
Loading...
