42
4 TG589vac web interface
DMS3-CTC-25-226 v1.0. Copyright © 2016 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
4.3.4 Wireless
The Wireless card
The Wireless card displays:
The status of the wireless access points (enabled or disabled).
The network name (SSID) of the 2.4 GHz and 5 GHz access point.
Wireless ON/OFF switch
In the Wireless card header, you can see whether the wireless interface is enabled or not. If the switch is set to:
then the wireless radio is enabled. Clicking the switch will disable the wireless radio. As a result all access points on
your TG589vac will be switched off.
then the wireless radio is disabled. Clicking the switch will enable the wireless radio.
The Wireless page
Click the Wireless card header to open the Wireless page.
On the left of the Wireless page you can select the access point that you want to configure:
For each access point, you can:
View or change the wireless interface settings.
View or change the access point settings
Start a WPS push button configuration
Generate a QR code to connect a wireless client.
Configuration examples
In this Setup and User Guide you can find information on how to:
Change the wireless security settings.
For more information, see “3.4 Securing your wireless connection” on page 29.
Configure and use WPS.
For more information, see “3.1 Connecting your wireless client via WPS” on page 24.
Use the QR code.
For more information, see “3.3 Connecting your wireless client by scanning a QR code” on page 28.
This is in fact the software equivalent of the Wireless button on the housing.
For more information, see “Wi-Fi On/Off button” on page 10.
To Next Page
Loading...
