66
7 Support
DMS3-CTC-25-226 v1.0. Copyright © 2016 Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use, extraction and
communication of its contents, is not permitted without written authorization from Technicolor.
7.4 Reset to factory defaults
Resetting your TG589vac
If at some point you can no longer connect to the TG589vac or you want to make a fresh install, it may be useful to perform
a reset to factory defaults.
Methods
You can choose between:
Resetting the TG589vac via the web interface
Reset the TG589vac via the Reset button
Resetting the TG589vac via the web interface
Proceed as follows:
1 Browse to the TG589vac web interface.
For more information, see “4.1.1 Accessing the TG589vac web interface from your local network” on page 34.
2 Click Gateway. The Gateway page appears.
3 Click Reset.
4 The TG589vac restores the factory default configuration and restarts.
Reset the TG589vac via the Reset button
Proceed as follows:
1 Make sure the TG589vac is turned on.
2 Push the Reset button for at least 7 seconds and then release it.
3 The TG589vac restarts.
A reset to factory default settings deletes all configuration changes you made. Therefore, after the reset a
reconfiguration of your TG589vac will be needed.
Also your wireless clients will have to be re-associated, as described in “3 Wireless networking” on page 23.
Your system administrator may have disabled the physical reset button of the TG589vac. In this case, a hardware
reset to defaults is not possible.
To Next Page
Loading...
