Technics SA-DX930

Changing the remote control code SA-DX930 only
Change the remote control code in either of the following circumstances:
€ if the Panasonic TV or VCR does not operate as a result of a difference in the remote control code.
€ if you wish to operate some other make of TV or VCR.
(9 Refer to pages 36 and 37 for the buttons which can be used.)
Even after changing the code there may be cases where certain operations cannot be done or operation is not possible at all.
How to change the remote control code
Hold down the button corresponding to the
component you wish to operate.
c a
» TAPE CD Continue to hold the button down and...
mc oO
Y
y
Y
Y (8
Aim the remote control at the component you wish
to operate and carefully and slowly press the
numeric buttons to enter the appropriate two-digit
code number.
(Refer to the table below for the code number.)
i ^
<
= m am
TITLE C
()
GC)
C. y
coc
e m LI x m < m
0-010
d 3
When the two-digit code number is entered, the remote control will
automatically output the on/off signal.
x = m
D
If the remote control has been correctly changed to the code for the
component to be operated, the component will be switched ON or
OFF.
If there is more than one code number indicated in the code table,
repeat the above procedure until you find a code number for which the
power of the component is switched ON or OFF.
000-00 00000
90000
CR QO
i
zi =
@
l
Q 2
+
Q
Q ?
TV VCR
[Manufacturer [Code No. | Manufacturer _] Code No. — |Manulacturer [Code No. _ | Manufacturer [Code No. |
r E nee | 03,07,09,13,23, [Panasonic _ |01,02,09.33 | Phiips ^ |02,09,12
24,25
Sony 05,06,07,35,36, [Pioneer |09 —— |
Fer — —|:4— je a a | 37
GE 02030709 [Sharp [0821 |Fisher | 13,14,15,18 [RCA 02,03,04,09,10,
fase arts — sys [0018 [rel ^ aa)
[Hitachi ^ 0507 [Symphonic [i7 . Jee . — 0203.41 [Sanyo 1418 |
VC i2 -Toshba — —|1021 — GoldSiar — 27 [Shap — [1617
03,06,07,10,14, [Zenith 118,26 — Hitachi 109,10,11__|Shintom — — |32
15
pave
—
meeseises
[one
[02001230
|
(Magnavox — [06071,1522 OO ë | — — ^| 40 [Symphonic 30 —
Meer eusma 1 dM | 10,13,14,15,18,
meo — fons ë O lcu ——3À 27,30 Zenith —— 120 |
[ILL LL ]Magavx [020932 — | | ——— | —-. |
Philips fos = 8— $1. . T .— Mitsubishi — |21222829 | — |
Pioneer — [021019 | — — à [| .— — |wecC — — [19253138 | — y O
(Quasar dlo? 1 1 | . . | [| .— — — [Philo | [lo209:230 | o To S
Changes to the codes are cancelled when the remote control's batteries are replaced. Repeat the above operation to reenter the code.
—— M MA A i ———À—— a M MM — a
ions
Remote control operat
RQT4918