Technics SC-CH717 User Manual

oDo not cover the hole or slits.
Otherwise the incorrect operation will take place.
aDo not insert another disc onto tray placed at (_), although the tray
is partially showing, its disc is in the play position.
Slit Hole
O
you play disc 2)
abe sure to load the discs correctly in the center position as shown
in the drawing.
3" (8 cm) CD
5" (12 cm) CD
ado not touch the carousel or the loading drawer while it is moving.
oDo not turn the tray forcibly by hand because it may fail to operate
normally.
elf the discs are not correctly loaded, playback may not start. In such
a case, reinsert the disc as follows:
1. Switch the power to the standby mode on the amplifier, and
then back on.
2. Press OPEN/CLOSE to open the loading drawer.
3. Load the disc(s) on the tray(s) correctly.
elf you press OPEN/CLOSE while the play indicator (D) is lit in
green, the drawer will open to half position.
To open fully, follow the procedure below.
1. Press [3.
2. Press OPEN/CLOSE to close the loading drawer.
3. Press OPEN/CLOSE again to open the drawer.
ado not move this changer with a compact disc inside the unit. If a
disc comes off the disc tray, it might be scratched or the changer
might become incapable of playing.
To select the desired discs
Press DISC 1, DISC 2 or DISC 3
____ to select the disc which
you
want to play.
The play will automatically start from the
first track of the disc you select.
To confirm the total playing time of the disc
currently playing
ISPLAY
Press DISPLAY.
The display will change (as described
below) each time you press the button.
In the stop mode:
O The display shows the total playing
time of the disc currently playing.
(_) The display shows the disc number
and the total track number of the disc
currently playing.
l_ --
_==_ o ,-'l l ,:-'r_._._ 0
In the play mode:
(_) The display shows the track number
of the disc currently playing.
: :-'&_ & -18I- ':' ,? _>1
J
(_) The display shows the elapsed time
of the track currently playing.
1
_'_ _ _ - - I'-/. '-' ' [_>
To exchange discs during play
While a disc is playing, you can exchange discs.
1. Press OPEN/CLOSE during playing.
The loading drawer will open at half position.
2. Exchange the discs.
3. Press OPEN/CLOSE again to close the loading drawer.
After the last track on the current disc finishes playing, the changer
will play all the remaining disc(s) loaded, and then stop.
If you play a disc with the loading drawer open, the changer will
automatically stop when the last track on the current disc finishes
playing.
20

Technics SC-CH717 Specifications