Technics SC-CH717 User Manual

Check that the tape's erasure prevention tabs (see page 57) are
intact, and then insert the cassette into deck 2.
The leader tape must be wound on beforehand. (See page 31 .)
_ Press _ OPEN on deck 2 to
load a cassette.
2 PressCLOSEon°ec.2toclose the cassette holder.
_0Lav,R When making a recording
-_:,._(- using Dolby NR, press DOLBY
%
NR so that the DOLBY NR IN
indicator lights.
REVERSEMODE
Press REVERSE MODE to se-
lect the reverse mode you
want to use.
: One side will record, and
then the tape will stop au-
tomatically at the tape end.
G-_,.O("_,_d'_: Both sides will record (for-
ward side->reverse side),
and then the tape will stop
automatically at the tape
end.
\1/
CCR_,O_- Press CCRT to activate the
" CCRT (Computer Control Re-
cord Tuning--see page 31)
function.
l VOLUMEMULXlCONTROL
• _"---- TUNI_m
;1¢ L-IL-t , ....
F_E_¢-T'T --- ....
!
. I_ #-! ! _ l-I-_--_E_
'-E T '-'
-) cJ
When the CCRT function is activated, the
test signal for adjustment will be re-
corded on the tape, so the previous re-
cording will be automatically erased•
You can record without using the CCRT
function.
6
PAUSE
%
Press REC PAUSE to put the
cassette deck into the record-
ing standby mode; then select
the desired sound source.
REC PAUSE indicator lights.
_ Press TUNER/BAND, and then
<1 or • on the tuner/sound
processor to tune in to the de-
sired station.
8
Press <3 or D to start record-
ing.
L>: When recording on either the for-
ward side or both sides
<3: When recording only the reverse
side
3O

Technics SC-CH717 Specifications