Technics SC-CH717 User Manual

_i_!::i:!_!ii_i_!_ii!_!_i_i_i_i_iii_ii_iiii_iiiiiiiiiiiii_iii_i_i_i;i_iii_ii_i_!_iiiii_!_ii_iiiii_i_iiiiiiiii_ii_i_i_i_iii_ii_i_i_i_i_i_i_i_i_i_i_ii_ii_i_i_i_iiiiiii_ii_ii_iiiiiiiiiiiiii_iiii_iiiiiiiiiiiii_iiiiiii_iiiiiiiiii_iii_ii_iiiii@iiiiiii_iiiii_iiii_ii_i_i_iiii_i_i_i_i_i_iiiiii_ii_i_i_iiiii_i_i_i__ _ii_iiiii_iiii_ii_iiii_iiii_i_ii!iii!iii_iiiiiiii_ii_iii_iiiiiiii@_iii_i_ii_i_i_iii_i_i_i_iii_iiiiii_i_'iiiii_iii@iii_i_iiiiiiiiiiiiiiiiii_ii_i_i_i_
i_i_i_i_i_i_i_:_/:_.1_ __ _%_;_;_i_ _;_iii_i__iiii!!_!i!_i_!!i_!!i!iiii!!_!i_!i_!!iii!!i!i!!i_ii!!i!i!iii!!iiii!!i!!!!!!!!i!!!!!!!!!iiiii!!i!ii!!i!i!_!!!!i!i!iiiii_!!!i!ii!iii_i!i_iiiii_!_iii_iiii_i_i_iii_iii_i_i_i_ii_i_i_i_ii_i_ii_ii_i_i_i_i_i_ii_i_i_i_i_i_i_i_i_i_i_i_i_ii_ii_i_i_iiii_i_i_i_ii_i_i_i_i_i_i_iiii_i_iii_i_ii_iiiiiiiiiiii_!iiiiiiiii!!i!!!!i!i!i!iiiiiiii!i!iii_!!iiiiiiii_ii!!!iiiiii_iii_iiiii_i_i_i_i_i_ii_i_i_i_i_i_ii_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_i_ii_i_i_i_i_i_i_i_i_ii_i_i_i_iiii_iiii!iiiii!i_i!i!iiii_iiii!iiiiiiii_!iii!ii
Sequential playback between 2 tapes
You can listen to two tapes consecutively with the procedure below.
1 345 2 6 1
I
I "t..
/
(
,I,
[] l
_ _ Load cassettes in decks 1 and
2.
Load with the side that you wish to listen
to first facing you in deck 1.
2 Press CLOSE to close each
deck's cassette holder.
DOLBYNR
Press DOLBY NR if the cas-
sette you want to play was re-
corded using Dolby NR.
The DOLBY NR IN indicator will light up.
If the tape was not recorded using Dolby
NR, press DOLBY NR and the DOLBY
NR OUT indicator will light up.
REVERSEMODE
o o_o_
%
Press REVERSE MODE to set
to the c_._ mode.
-_O_-I-OECK-2©Press DECK 1/2 to select
deck 1.
The DECK 1 indicator lights to show you
can select deck 1.
Press D to start playback.
Two tapes will play back as follows:
]
Forward side of tape in deck 1
/
f
Reverse side of tape in deck 1
f
Forward side of tape in deck 2
/ /
J Reverse side of tape in deck 2 I-_
J
After repeating above operation 8 times,
the tape will automatically stop.
L_i__J To stop sequential tape play:
Press [q.
For your reference:
oYou cannot select Dolby NR for deck 1 and deck 2 respectively.
eWe recommend that you use cassettes of the same type (Dolby
noise reduction) in both decks.
eYou can also start playback from a position other than the forward
side of the tape in deck 1.
About priority of the deck:
When you load cassettes in both decks, DECK 1 or 2 indicator will
light to show which deck you loaded last.
When you switch on the power, DECK 1 indicator will light.
28

Technics SC-CH717 Specifications