Technics SC-CH717 User Manual

i!i!iii!i!i!:
Playback
You can use either deck 1 or deck 2 for tape playback. 2
You can use normal, chrome and metal tapes for playback.
1 7
This page shows an example using deck 1.
POWER
STANDBY Switch on the power on the
STANO_BN amplifier.
_ Press _ OPEN, and then in-
sert the cassette you wish to
play.
Insert the cassette with the exposed tape
facing down.
_ Front side
_ Press CLOSE on deck 1 to
close the cassette holder.
ym==::::,=_j_ Press here.
Press DOLBY NR if the cas-
sette you want to play was re-
corded using the Dolby NR.
The DOLBY NR IN indicator will light up.
If the tape was not recorded using Dolby
NR, press DOLBY NR and the DOLBY
NR OUT indicator wi/I/ight up.
,EVERSE_0OE Press REVERSE MODE to se-
o-_y._-u_ lect the reverse mode you
%
want to use.
Each time you press REVERSE MODE,
one of the indicators will light up to show
which mode you selected.
45 3 6
I
The player plays one side only,
and then the tape automatically
stops.
C",.__: The player plays both sides
8 times, and then the tape auto-
matically stops.
C_.,_: The player plays both sides of the
tape, then automatically stops.
When you load cassettes into
both decks, the deck makes a
sequential playback between
2 tapes. (See page 28.)
D: The forward side (front side) will
play.
<3: The reverse side will play.
VOLUME Adjust the volume level as you
oo_/[/_\\u_p_ like on the amplifier.
____] To stop tape playback:
Press FI.
-_O,'t-DECK-20 To change the deck to be
used:
Press DECK 1/2 to select the deck you
want to use.
DECK 1 or DECK 2 indicator will illumin-
ate to show which deck you can operate.
About <3 and I> indicator:
While halted: Lights in orange.
While playing, recording or finding the beginning of a program:
Lights in green.
For your reference:
The tape will automatically stop when a different sound source is
selected during its operation.
26

Technics SC-CH717 Specifications