Technics SC-CH717 User Manual

,/
Listening to an external source
You can connect DCC (or DAT) or analog turntable to this system.
The following example shows when you select DCC.
EXT
1 %
Press EXT to select the exter-
nal source.
7"// / .VOLUUeMULtiCON_AOL
IlL L
I--I I'-/ T
F" L I"t i
Each time you press EXT, "DCC" and
"AUX" will be alternately displayed.
Operate the unit which is con-
nected to the system.
See the instruction manual of the unit
concerned for operating instructions,
Recording from an external source
The following example shows when you record from an analog
player.
f_
\1/
PAUSE
%
Press REC PAUSE on the cas-
sette deck to put the cassette
deck into the recording stand-
by mode.
EX: Press EXT to select an exter-
nal source from which you
want to record.
_U_ Start playing the source to be
recorded.
See the instruction manual of the unit
concerned for operating instructions.
O
REC
PAUSE
%
To stop recording:
Press [] on the cassette deck.
To briefly interrupt recording:
Press REC PAUSE on the cassette deck.
The cassette deck will go into the record-
ing standby state.
To resume recording:
Press one of the playback buttons (<3 or
l>) corresponding to the direction in
which recording is taking place.
To record on a DCC (or DAT) tape:
Start recording on a DCC (or DAT), and then start playing the source
to be recorded.
You cannot record the sound with the equalization curve, simulated
listening environment, and V.BASS effect on a DCC (or DAT) tape.
Do not press KARAOKE when recording on a DCC or DAT.
_, [_ Press one of the playback but-
,:: tons (<3 or D) on the cassette
deck to start recording.
53

Technics SC-CH717 Specifications