Technics SC-CH717 - Using the Sleep Timer

To use the sleep timer
_'qb_c_ use _._,\s_\me_ _£_\_r_ \e sw_\ch _.hepower to the standby
mode at a specified time (within a range of 1 minute to 120 minutes
from the present time).
J,I
CLOCK/ 1
T|MER
2
J
O0
The following example shows how to set the system to standby
mode after 30 minutes.
While enjoying the desired source:
1
clocK/ (_)Press CLOCK/TIMER four
TIMER
times to select SLEEP.
I--I I-- I--I--I 4
41, -" "- '-- '- "" --*_'_"......
%
Within 7 seconds:
(_ Press SET.
(_ Press < or I_ to select the
desired length of time.
0000
0000
0000
0000
0000
0000
0000
0000
C5_<559
SLEEP
Q2)
CLOCK/
TIMER
%
To confirm the time remaining
on the sleep timer:
Press CLOCK/TIMER four times.
To change the time setting while sleep timer is
functioning:
Follow procedure from the beginning.
If you want to operate the system again on the
same sleep time:
Press SLEEP on the remote control to show "SLEEP" on the display,
(_)Press SET.
Please confirm SLEEP appears on
the display.
SLEEP
To cancel the sleep timer
mode:
Press SLEEP to go out the SLEEP on the
display.
The time setting will remain in the unit's
memory.
5O