Technics SC-CH717 User Manual

Linking up several discs (LINK)
When "LINK" indicator flashes after the edit-recording of loaded
disc(s) has finished, you can subsequently edit-record the same or
another disc(s) on the remaining blank portion of the tape.
='1
I o_1
to,._=zm=_..OjL= _ o-. I
• O
Finish the first edit-recording of the loaded disc(s).
1 _ Press OPEN/CLOSE to replace
disc(s) and press it again.
The time remaining on tape
i,i,i i ' -,[.:_
Flashes.
2 ,ress
The recording will start from the disc on
the disc tray 1, with the same editing
mode of the first disc.
The system will assign tracks to be re-
corded on the remainder of the tape and
display the results.
Tracks to be recorded on tape side A
Tracks to be recorded on tape side B
The recording will start after the system
completes the ATLS (see "One-touch
editing operation" on page 35) setting.
o
1 2
To cancel the LINK function
Press Iq.
To specify the tracks to be edited:
(Steps 2-5 are available only from the remote control.)
1. Replace the CD.
2. Press PROGRAM.
3. Press DISC.
4. Press one of the numeric buttons (1-3) to select disc number.
5. Press numeric buttons to specify the tracks you want to record.
6. Press D to start recording.
To record from the same disc(s) in succession:
Follow steps 2-6 above•
Repeat steps 1-2 to record
more discs.
• When you record the first compact disc using LAST FADE, tracks
to be recorded will not be displayed. However, it is possible to
record from another disc.
eWhen the display shows "0:00", you cannot record from another
disc. Press [] to cancel the edit mode.
elf the time remaining on the tape is shorter than the length of the
tracks to be recorded, you cannot record the tracks. Replace the
disc with the tracks shorter than the time remaining on the tape or
press [] to cancel the edit mode.
37

Technics SC-CH717 Specifications