TechniSat DigitRadio 110 IR

36
4. When the display shows ‘Alarm Saved‘, the alarm seing is successful. or will show on the display.
5. To temporarily switch o alarm, press SNOOZE buon to activate Snooze function when the alarm is
sounding. Press SNOOZE buon repeatedly can set Snooze time of 5, 10, 15 or 30 minutes in turn. The
set snooze time will show on the display.
6. To turn o alarm, press buon when the alarm is sounding.
7. To cancel Alarm, refer to steps 1-3 to enable alarm ‘O’.
11.3 Seing Equaliser
This feature enables you to choose a sound equalization profile. Each of the equalization seing will change the
tone of the sound from your radio when selected.
1. Press MENU buon > Main menu > System seings > Equaliser, and then press OK buon to confirm.
2. Press or buon to select through Normal, Flat, Jazz, Rock, Movie, Classic, Pop, News, My EQ or My
EQ profile setup, and then press OK buon to confirm.
3. To set up My EQ, select ‘My EQ profile setup’, and then press OK buon to confirm. Press or buon
to select Bass or Treble, and then press OK buon to confirm. Press or buon to change the value
of Bass or Treble, and then press OK buon to confirm. Press buon, display will show ‘Save changes’.
Press or buon to select ‘YES’ and then press OK buon to save changes.
11.4 Network Setup
Users encountering networking issue may find these options useful for diagnosing and fixing network problems.
1. Press MENU buon > Main menu > System seings > Network, press OK buon to confirm.
2. Press or buon to select your preferred network seing option:
Network wizard: Scan for available networks
PBC Wlan setup: Set up a WPS encrypted network (only support the
router uses WPS 2.0)