TechniSat DIGITRADIO 580

40
9 FM Mode
9.1 Selecting FM Mode
1. Press MODE buon repeatedly to select FM mode.
2. For initial use, it will start at the beginning of the FM frequency range (87.50MHz). Otherwise, the last
listened FM station will be selected.
3. To manually change the FM frequency, while FM frequency shows up, turn SCROLL/SELECT/SNOOZE
knob clockwise or anticlockwise to change the frequency by 0.05MHz per step.
4. To automatically scan, while FM frequency shows up, turn SCROLL/SELECT/SNOOZE knob clockwise or
anti-clockwise and then press SCROLL/SELECT/SNOOZE knob, your radio will skip forward or backward
until it reached the next available station.
9.2 Scan seings
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio (hiss) from weak
stations.
1. To change the scan seings to stop only at stations with good signal strength, press MENU buon, turn
SCROLL/SELECT/SNOOZE knob to select “Scan seing”, and then press SCROLL/SELECT/SNOOZE knob to
confirm.
2. Display will show “Strong stations only?”, turn SCROLL/SELECT/SNOOZE knob to select “YES”, and then
press SCROLL/SELECT/SNOOZE knob to confirm.
40