TECHTOP TD350 - Page 186

TD350 Series VFD Function parameter list
-181-
Function
code
Name
Detailed parameter description
Default
value
Modify
P08.43
Reserved variables
/
/
P08.44
UP/DOWN
terminal control
setting
0x000–0x221
Ones: Frequency control selection
0: UP/DOWN terminal setting is valid
1: UP/DOWN terminal setting is invalid
Tens: Frequency control selection
0: Valid only when P00.06=0 or P00.07=0
1: All frequency modes are valid
2: Invalid for multi-step speed when multi-step
speed takes priority
Hundreds: Action selection during stop
0: Valid
1: Valid during running, clear after stop
2: Valid during running, clear after receiving stop
command
0x000
○
P08.45
UP terminal
frequency
incremental
integral rate
0.01–50.00Hz/s
0.50Hz/
s
○
P08.46
DOWN terminal
frequency
decremental
change rate
0.01–50.00Hz/s
0.50Hz/
s
○
P08.47
Action selection
for frequency
setting during
power down
0x000–0x111
Ones: Action selection for frequency setting (by
keypad digits) during power down
0: Save during power down
1: Zero out during power down
Tens: Action selection for frequency setting (by
Modbus/Modbus TCP) during power down
0: Save during power down
1: Zero out during power down
Hundreds: Action selection for frequency setting (by
other communication) during power down
0: Save during power down
1: Zero out during power down
0x000
○
P08.48
High bit of initial
value of power
consumption
Set the initial value of power consumption.
Initial value of power consumption=P08.48×1000+
P08.49
0 kWh
○