TECHTOP TD350 - Page 204

TD350 Series VFD Function parameter list
-199-
Function
code
Name
Detailed parameter description
Default
value
Modify
P12.29
Parameter
display of motor 2
0: Display based on the motor type; under this
mode, only parameters related to current motor
type will be displayed.
1: Display all; under this mode, all the parameters
will be displayed.
0
○
P12.30
System inertia of
motor 2
0–30.000kgm
2
0.000
○
P12.31–
P12.32
Reserved
variables
0–65535
0
○
P13 group Control parameters of synchronous motor
P13.00
Reduction rate of
the injection
current of
synchronous
motor
This parameter is used to set the reduction rate of
the input reactive current. When the active current
of the synchronous motor increases to some extent,
the input reactive current can be reduced to
improve the power factor of the motor.
Setting range: 0.0%–100.0% (of the rated current of
the motor)
80.0%
○
P13.01
Initial pole
detection mode
0: Disabled
1: In pulse detection mode
2: In pulse detection mode
0
◎
P13.02
Input current 1
Input current is the pole position orientation current;
input current 1 is valid within the lower limit of input
current switch-over frequency threshold. If users
need to increase the starting torque, increase the
value of this function code properly.
Setting range: 0.0%–100.0% (rated motor current)
20.0%
○
P13.03
Input current 2
Input current is the pole position orientation current;
input current 2 is valid within the upper limit of input
current switch-over frequency threshold, and users
do not need to change input current 2 under
common situations.
Setting range: 0.0%–100.0% (rated motor current)
10.0%
○
P13.04
Switch-over
frequency of
input current
0.00Hz–P00.03 (Max. output frequency)
10.00H
z
○
P13.05
High-frequency
superposition
frequency
(reserved)
200Hz–1000Hz
500Hz
◎