TECO A510-2001-H - 08-23 Ground Fault (GF) selection

4-30
Control mode
Code Parameter Name Range Default Unit
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
Attrib
ute
09-06
Communication error
detection time
0.0~25.5 0.0 S O O O O O O
0: Decceleration to stop based
on deceleration time 1 when
communication fault occurs.
1: Coast to stop when
communication fault occurs.
2: Decceleration to stop based
on deceleration time 2 when
communication fault occurs.
09-07 Fault stop selection
3: Keep operating when
communication fault occurs.
3 - O O O O O O
09-08 Retain
09-09 Waiting time 5~65 5 ms O O O O O O
Group 10 PID Function Group
Control mode
Code Parameter Name Range Default Unit
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
Attrib
ute
1:AI1 given
2:AI2 given
3:Retain
10-00
PID target value source
setting (00-05=5 this
parameter is enabled)
4:10-02 given
1 - O O O O O O
1:AI1 given
2:AI2 given
10-01
PID feedback value
source setting
3:Retain
2 - O O O O O O
10-02 PID target value 0.0~100.0 0.0 % O O O O O O
xxx0b: PID invalid
xxx1b: PID valid
xx0xb: PID positive
characteristic
xx1xb: PID negative
characteristic
x0xxb: PID error value of D
control
x1xxb: PID feedback value of D
control
0xxxb: PID output
10-03 PID control mode
1xxxb: PID output + target
value
0000b - O O O O O O
10-04 Feedback gain 0.01~10.00 1.00 - O O O O O O *1
10-05 Proportional gain (P) 0.00~10.00 1.00 - O O O O O O *1
10-06 Integral time (I) 0.0~100.0 1.00 s O O O O O O *1
10-07 Differential time(D) 0.00~10.00 0.00 s O O O O O O *1
10-08 Retain
10-09 PID bias voltage -100.0~100.0 0 % O O O O O O *1