TECO E310 Series User Manual

4-15
12-User parameter group
Function
Code No.
Description
Range/Code
Factory
Setting
Remarks
12-00 Drive Horsepower Code ----- *3
12-01 Software Version ----- ----- *3
12-02 Fault Log (Last 3 Faults) ----- *3
12-03
Accumulated Operation Time1
(Hours)
0~23 ----- *3
12-04
Accumulated Operation Time2
(Days)
0~65535 ----- *3
12-05 Accumulated Operation Time Mode
0 : Time Under Power
1 : Run Mode Time Only
0 *3
12-06 Reset Drive to Factory Settings
1150 : Reset to the 50Hz factory setting
1160 : Reset to the 60Hz factory setting
----
12-07 Parameter Lock
0 : Enable all Functions
1 : 03-01~03-08 cannot be changed
2 : All Functions cannot be changed
Except 03-01~ 03-08
3 : Disable All Function
0
12-08 Parameter password 00000~65535 00000
13-Auto Run function group
Function
Code No.
Description Range/Code
Factory
Setting
Remarks
13-00
Auto Run( sequencer) mode
selection
0 : Disabled.
1 : Single cycle. (Continues to run from the
unfinished step if restarted).
2 : Periodic cycle. (Continues to run from the
unfinished step if restarted).
3 : Single cycle, then holds the speed Of final step to
run.(Continues to run from the unfinished step if
restarted).
4 : Single cycle. ( starts a new cycle if restarted).
5 : Periodic cycle. ( starts a new cycle if restarted).
6 : Single cycle, then hold the speed of final step to run.
( starts a new cycle if restarted).
0
13-01
Auto _ Run Mode
Frequency Command 1
0.00 ~ 400.00 (Hz) 0.00
13-02
Auto _ Run Mode
Frequency Command 2
13-03
Auto _ Run Mode
Frequency Command 3
13-04
Auto _ Run Mode
Frequency Command 4
13-05
Auto _ Run Mode
Frequency Command 5
13-06
Auto _ Run Mode
Frequency Command 6

TECO E310 Series Specifications

General

Brand	TECO
Model	E310 Series
Category	Controller
Language	English