4-62
00- 01 Motor’s Rotation Direction
Range
【0】：Forward
【1】：Reverse
Use the FWD/REV key to change motor direction when Run Command Selection
(00-02=0) is set to keypad control.
00- 02 Main Run Command Source Selection
Range
【0】：Keypad
【1】：External Terminal (Control Circuit)
【2】：Communication Control (RS-485)
【3】：PLC
(1) 00-02=0：Keypad
Use the keypad to start and stop the inverter and set direction with the forward /
reverse key). Refer to section 4-1 for details on the keypad.
(2) 00-02=1：External Terminal
External terminals (00-04) can be used to start and stop the inverter and select motor direction.
Please refer Fig. 4.3.1 for two wire control mode.
Please refer Fig. 4.3.2 for three wire control mode.
(3) 00-02=2：Communication
Communication port (RS485) can be used to start and stop.
Please refer parameter 09 for RS-422/485communication control.
(4) 00-02=3：PLC
Parameter 00-05 is invalid when the run and stop command is used by PLC function.
PLC function can be stopped by RUN/STOP key of the keypad.
00- 03 Alternative RUN Command Selection
Range
【0】：Keypad
【1】：External terminal control
【2】：Communication control
【3】：PLC
(1) 00-03=0：Keypad Control
Use the keypad to start and stop the inverter and set direction with the forward / reverse key).
Refer to section 4-1 for details on the keypad.
(2) 00-03=1：External terminal control
External terminals are used to start and stop the inverter and select motor direction.
Note：It is required to be used with multi-function digital input
(12：main and alternative run switch function).
To Next Page
Loading...
