TECO E510s Series - LED Display Setup

4-4
LED status description
LED indicator light status LED indicator flashing status
Frequency / Line
speed Indicator
Hz/RPM
ON while displaying frequency or linear speed
Menu mode
indicator
FUN
ON while not
displaying
frequency or line
speed
Flashing while fire
mode enabled
FWD indicator
FWD
ON while running
forward
FWD
Flashing while
stopped in
Forward mode.
REV indicator
REV
ON while running
reverse
REV
Flashing while
stopped in
Reverse mode
4.1.3 LED display setup
On power up, digital display screens will be shown below.
DSP/FUN
DSP/FUN
User selectable display formats：
12- 00 Display mode
Range
0 0 0 0 0
High Low
Each of the 5 digis can be set to any of the selections below from 0~8.
【0】：Display display 【1】：Output current 【2】：Output voltage
【3】：DC voltage 【4】：Temperature 【5】：PID feedback
【6】：AI1 input value 【7】：AI2 input value 【8】：Counter Value
The highest bit of 12-00 sets the power on the display, other bits set the selected display from range
0-7, as the liste above.