TECO E510s Series - Keypad Menu Structure

4-10
4.1.7 Keypad menu structure
 Main menu
The E510s inverter parameters consists of four main modes. The DSP/FUN key is used to switch
between these modes. (Please refer Fig.4.1.7.1)
Power On
Power Up
Monitor Mode
Parameter Group Mode
Parameter Group Mode
Parameter Edit Mode
View inverter status, signals and fault data
Assess to available parameter groups
Select parameter group
Auto-tune function of motor
Auto-tune Mode
Change parameter setting
Fig. 4.1.7.1 Parameter Group Structure
Notes：
 Always perform an auto-tune on the motor before operating the inverter in sensorless vector
control. Auto-tune mode will not be displayed when the inverter is running or when a fault is
active.
 To scroll through the available modes, parameter groups or parameter list press and hold the up
or down key.