3-17
dn-03 (Digital input contact signal status)
Users can use
dn-03
to check current digital input contact signal status. The following is the
description of panel display:
11
12
LED No.
Press Mode
to switch
When a digital input contact signal status is ON, the corresponding LED will light up; when a
digital input contact signal status is OFF, the corresponding LED will not light up. The following
comparison table shows LED No. and digital input contact code.
DI-1
~
DI-12
are multifunction
planning contact and can be set by
Hn601~Hn612
. They can also be set as switch in conduction or open
under ON status. For detailed setting information, please refer to “5-6-1 Digital input/output contact
function planning".
For DI-11 & DI-12, please monitor through Un-31 digital input contact status (DI).
LED No. Digital input contact code
1 DI-1
2 DI -2
3 DI -3
4 DI -4
5 DI -5
6 DI -6
7 DI -7
8 DI -8
9 DI -9
10 DI -10
11 DI -11
12 DI -12
To Next Page
Loading...
