5-25
5-3-2 Analog speed command
JSDG2S-E(L) does not have this function
Adjust the slope of Voltage Command relative to the Speed Command in coordination with the
Analog Speed Command Proportioner.
Sn216 Analog speed command proportioner JSDG2S-E(L) does not have this function
Initial Value Unit Setting Range Effective RS-485 Address
Rated Speed rpm/10V 100 ~ 10000 Effective after Set 0210H
Setting Description: Used to adjust the slope of Voltage Command relative to the Speed Command.
Setting Example:
(1) If Sn216 is set to 3000, it means Analog Input Voltage 10V corresponds to 3000rpm Speed
Command; if Analog Input Voltage is 5V at this time, then it corresponds to 1500rpm Speed
Command.
(2) If Sn216 is set to2000, it means Analog Input Voltage 10V corresponds to 2000rpm Speed
Command; if Analog Input Voltage is 5V at this time, then it corresponds to 1000rpm Speed
Command.
Note: The displayed speed needs to be determined according to the different motors.
To Next Page
Loading...
