TECO JSDG2S-100A3-E - Page 183

5-58
Pn302 Electronic Gear Ratio Numerator 1
Initial Value Unit Setting Range Effective RS-485 Address
1 -- 1 ~ 536870912 Effective after Set 0302H/0303H
Pn303 Electronic Gear Ratio Numerator 2
Initial Value Unit Setting Range Effective RS-485 Address
1 -- 1 ~ 536870912 Effective after Set 0304H/0305H
Pn304 Electronic Gear Ratio Numerator 3
Initial Value Unit Setting Range Effective RS-485 Address
1 -- 1 ~ 536870912 Effective after Set 0306H/0307H
Pn305 Electronic Gear Ratio Numerator 4
Initial Value Unit Setting Range Effective RS-485 Address
1 -- 1 ~ 536870912 Effective after Set 0308H/0309H
Pn306 Electronic Gear Ratio Denominator
Initial Value Unit Setting Range Effective RS-485 Address
1 -- 1 ~ 536870912 Power Re-set 030AH/030BH
Setting Description: Set Pn306 (Electronic Gear Ratio Denominator) and coordinate with the
Electronic Gear Ratio Numerator selected by Digital Input Contact GN1, GN2;
the obtained Electronic Gear Ratio must conform to the following conditions,
otherwise this Device cannot operate normally.
1
1000
 ElectronicGearRatio  32000
This Device provides four sets of Electronic Gear Ratio Numerators. Users can utilize Digital
Input Contact GN1, GN2 to switch to currently required Electronic Gear Ratio Numerators. Please
refer to the following Table:
Input Contact
GN2
Input Contact
GN1
Electronic Gear Ratio
Numerator
Electronic Gear Ratio
Denominator
OFF (Switch does
not function)
OFF (Switch does
not function)
Electronic gear ratio
numerator 1 (Pn302)
Electronic Gear Ratio
Denominator (Pn306)
OFF (Switch does
not function)
ON (Switch
functions)
Electronic gear ratio
numerator 2 (Pn303)
Electronic Gear Ratio
Denominator (Pn306)
ON (Switch
functions)
OFF (Switch does
not function)
Electronic gear ratio
numerator 3 (Pn304)
Electronic Gear Ratio
Denominator (Pn306)
ON (Switch
functions)
ON (Switch
functions)
Electronic gear ratio
numerator 4 (Pn305)
Electronic Gear Ratio
Denominator (Pn306)
Note) Please refer to ”5-6-1 Digital Input / Output Contact Function Planning” to set the Driver
Effective Logic.