5-93
JSDG2S (-E) tool magazine can be switched through DI to providemultiplecontrol modes; the
outlines of the various modes are as follows:
Tool magazine control operation mode comparison table:
Digital input
contact
Mode
MDC1 MDC2 MDC3
Automatic tool selection shortest path tool
selection mode
OFF OFF OFF
Tool calibration reset to zero mode ON OFF OFF
Forward manual single-step mode OFF ON OFF
Automatic tool selection, single-turn too
l disc tool selection mode
ON ON OFF
Reserved OFF OFF ON
Reserved ON OFF ON
Reverse manual single-step mode OFF ON ON
Reserved ON ON ON
※ OFF means the contact has no action (Open); ON means the contact has action (Closed).
To Next Page
Loading...
