TECO JSDG2S-100A3-E - Page 379

7-17
Parameter Code Name and Function Unit RS485 Index
-- EC915 E-Cam rotary cut DO delay time 200us 080FH 270FH
-- EC916 E-Cam auxiliary axle screw pitch 0.1mm 0810H 2710H
-- EC917
Maximum proceeding distance of E-Cam rotary
cut auxiliary axle
0.1mm 0811H 2711H
-- EC918
Average proceeding speed of E-Cam rotary cut
main axle
rpm 0812H 2712H
-- EC919 Cumulative pulse quantity of E-Cam virtual axle mm 0813H 2713H
-- EC920 Maximum return speed of E-Cam rotary cut rpm 081CH 2714H
-- EC921
Acceleration/deceleration time of E-Cam rotary
cut
ms 081DH 2715H
-- EC922 Enable E-Cam parameter change write-in - 081EH 2716H
-- EC923 E-Cam parameter fine-tune factor 0.01 081FH 2717H
-- EC924.0 E-Cam rotary cut return origin return function - 0820H 2718H

Monitoring Parameters (Un-□□)
Parameter Code Name and Function Unit RS485 Index
-- Un-01 Actual Motor Speed rpm 0601H 2801H
-- Un-02 Actual Motor Torque % 0602H 2802H
-- Un-03 Regenerative Load Rate % 0603H 2803H
-- Un-04 Effective Load rate % 0604H 2804H
-- Un-05 Maximum Load Rate % 0605H 2805H
-- Un-06 Speed Command rpm 0606H 2806H
-- Un-07 Position Error pulse 0607H/0608H 2807H
-- Un-09 External Analog Voltage Command Value V 060BH 2809H
-- Un-10 Main Circuit (Vdc Bus) Voltage V 060CH 280AH
-- Un-11 External Analog Voltage Limit Value V 060DH 280BH
-- Un-12
External CCW Direction Torque Limit Command
Value
% 060EH 280CH
-- Un-13
External CW Direction Torque Limit Command
Value
% 060FH 280DH
-- Un-14
Motor Feedback - Number of Pulses in one
Rotation
pulse 0610H/0611H 280EH
-- Un-16 Motor Feedback - Number of Rotations rev 0613H/0614H 2810H
-- Un-18
Pulse Command - Number of pulses in one
rotation
pulse 0616H/0617H 2812H
-- Un-20 Pulse Command - Number of Rotations rev 0619H/061AH 2814H
-- Un-24
Multi-revolution Position Information of the
Communication Encoder Feedback
rev 061FH 2818H
-- Un-25
Single Revolution Position Information of the
Communication Encoder Feedback
pulse 0620H/0621H 2819H
-- Un-27 Communication Encoder Message - 0623H 281BH
-- Un-28 Torque Command % 0624H 281CH
-- Un-29 Load Inertia Ratio 0.1 0625H 281DH