TECO JSDG2S-100A3-E - Page 446

7-84
Pn324 CNC tool magazine quantity setting

【
5-5
】
Initial Value Unit Setting Range Effective Cn029 Reset
12 -- 1 ~ 64 -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
031FH -- -- -- -- O -- --
Setting Description: Total Number of Tool Holders on Tool Tray
Pn325 CNC Tool Tray Return to Zero Position

【
5-5
】
Initial Value Unit Setting Range Effective Cn029 Reset
0 pulse 0 ~ 8388607 -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0320H/0321H -- -- -- -- O -- --
Setting Description: Set the zero tool position
Pn326 CNC Tool Tray Reduction Ratio

【
5-5
】
Initial Value Unit Setting Range Effective Cn029 Reset
1 -- 1 ~ 16383 -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0322H -- -- -- -- O -- --
Setting Description: Set Pn306 and Pn326, to determine the CNC tool tray reduction ratio.
Pn327 Tool change rotational speed 1

【
5-5-1
】
Initial Value Unit Setting Range Effective Cn029 Reset
100 rpm 1 ~ 2*rated rotational speed -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0323H -- -- -- -- O -- --
Setting Description: Set digital input contact TRQINV=OFF under tool magazine mode and will change tool by the speed
of tool change rotational speed 1.
Pn329 Pulse Command Smoothing Filter

【
5-4-4
】
Initial Value Unit Setting Range Effective Cn029 Reset
0 2ms 0 ~ 2500
★
--
RS-485 CANopen EtherCAT Pi Pe Pt S T
0325H 231DH 231DH O O O -- --