3-7
The negative setting of this Device is explained as follows:
(1) If the settable value range is less than or equal to 4 digits, for example, set
Sn201
(Internal Speed
Command 1)=100 to -100
Steps
Operation
Key
LED Display Screen
after Operation
Description
1
Turn on
Power
When the power is turned on, Enter the
Status
Display Screen
.
2
Press MODE Key 6 times to enter
Speed Control
Parameters
.
3
After pressing, hold the ENTER Key for 2 seconds to
enter the
Sn201
setting screen.
4
Press the ENTER Key 4 times to move the adjustable
digits 4 places to the left, that is, to the highest digit.
5
or
Press the UP Key or DOWN Key 1 time, the negative
sign appears. If pressing one more time, then the
negative sign disappears.
6
Press and hold the ENTER Key for 2 seconds until -
SET- appears, indicating the current set value has been
saved and after the -SET- appears once, jumps back to
the current parameter item selection screen
immediately.
(2) If the settable range is equal to 5 digits, for example, set
Pn401
(Internal Position Command 1-
Number of Revolutions)=0 to -10000.
Steps
Operation
Key
LED Display Screen
after Operation
Description
1
Turn on
Power
When the power is turned on, Enter the
Status
Display Screen
.
2
Press MODE Key 8 times to enter the
Point to Point
Position Control Parameters
.
3
After press and hold the ENTER Key for 2 seconds,
enter the
Pn401
Setting Screen.
4
Press ENTER Key 4 times, to move the adjustable
digits 4 places to the left.
5
Press DOWN Key 1 time, to adjust the 10,000th digit
down to 1, and the decimal point of all digits is ON,
indicating that the current setting value is negative.
6
Press and hold the ENTER Key for 2 seconds until -
SET- appears, indicating the current set value has been
saved and after the -SET- appears once, jumps back to
To Next Page
Loading...
