TECO JSDG2S-100A3-E - Page 99

3-13
Parameter
Code
Display Content Unit Description
RS-485
Address
Index
Un-72
Turret monitor
parameter 2
0653H
Un-73
Turret monitor
parameter 3
0654H
Un-74
Turret monitor
parameter 4
0655H
Un-75
Turret monitor
parameter 5
0656H
Un-76
Turret monitor
parameter 6
0657H
Un-84
Encoder category ─
0: Incremental type
1: Absolute value type
065FH 2854H
Un-88
ServoOn total time hour ServoOn total time 0663H 2858H
Un-89
PowerOn total time hour PowerOn total time 0664H 2859H
Un-90
Effective load rate % Effective load rate
0665H 285AH
Un-91
Color mark distance 0.1mm
The travel distance of the spindle corresponding
to two DI signals
0666H 285BH
Un-92
Cut point error pulse
The error value of the spindle when the tool
reaches the cut point
0667H 285CH
Un-93
Slave axis state -
Un-93.0
0: Initialization completed
1: From the axis to the actual zero position, and
stop
2: The slave axis starts to run, but it has not yet
reached the synchronization area
3: The slave axis is in the synchronization area
4: The slave axis has passed the synchronization
area, but has not reached the logic zero position
Un-93.1
(DI 0x25 E-STOPIN input)
0: Allow slave axis running
1: The slave axis is not allowed to start a new
operating cycle
0668H 285DH
Un-94
Slave axis angle 0.01deg Slave axis angle
0669H
066AH
285EH
Un-95
Lost bids times time Lost bid times
066BH 285FH
Un-96
System unit quantity
position feedback
unit/PLS System unit volume position feedback
066CH
066DH
2860H
Un-97
System unit quantity
position command
unit/PLS System unit volume position command
066EH
066FH
2861H
Note 1: JSDG2S-E(L) does not have this function