TECO L510 - Page 110

4-76
12-05
Input and output terminal status display
Range
Read only (Keypad read only)
 Terminals S1-S5 are represented using two segments of each digit. Segment turns on when input is active.
 When relay output RY1 is on, the bottom segments of the first digit turns on (see below).
 When no Digital input and no relay output the display will show -----.
Example 1: Figure shows 12-05 display status: S1, S3, S5 Inputs are ON and S2, S4 and RY1 are OFF.
S 1 S 2 S 3 S 4 S 5
Example 2: Figure shows 12-05 display status: S2, S3, S4 Inputs are ON and S1, S5 and RY1 are ON.
RY1