TECO L510 - Page 57

4-23
00-12
Frequency Upper limit
Range
【0.01~599.00】Hz
00-13
Frequency Lower limit
Range
【0.00~649.99】Hz
 ” Stpo” is displayed on the keypad when RUN is pressed and parameter 00-13 and the command frequency
are both set to 0.00.
 When Frequency command is greater than 00-13 the inverter output will ramp up from 0.00 to the command
frequency.
 When 00-13 is greater than 0, and the frequency command value smaller or equal to 00-13, the inverter
output will ramp up to the lower limit frequency set by 00-13.
Frequency
Reference
Output
Frequency
100%
00-12
00-13
100%
00-14
Acceleration time 1
Range
【0.1~3600.0】s
00-15
Deceleration time 1
Range
【0.1~3600.0】s
00-16
Acceleration time 2
Range
【0.1~3600.0】s
00-17
Deceleration time 2
Range
【0.1~3600.0】s
 Acceleration time is the time required to accelerate from 0 to 100% of maximum output frequency.
 Deceleration time is the time required to decelerate from 100 to 0% of maximum output frequency.
 Preset Acceleration and Deceleration times by above parameters are the time taken for the output frequency
to ramp up or ramp down between the Upper and the lower frequency limits.
 Actual acceleration and deceleration time is calculated as follows：
(00-15) X (set frequency - the minimum starting frequency)
Actual acceleration time=
(00-14) X (set frequency - the minimum starting frequency)
Maximum output frequency
Actual deceleration time=
Maximum output frequency