TECO L510 - Page 60

4-26
 (V) 100% is the maximum output voltage. Point B and C are defined as a % of the maximum voltage see
table below:
01-00
Frame1/2
Frame3/4
B(Xb)
C(Xc)
B(Xb)
C(Xc)
1/4
10%
8%
6.8%
3.4%
2/5
12%
9.5%
6.9%
3.5%
3/6
25%
7.7%
25%
3.4%
 To set a custom V/F curve set 01-00 = [7]. Parameters (01-02~01-09) can now be modified.
01-01
v/f Maximum voltage
Range
230:【170.0~264.0】V
460:【323.0~528.0】V
01-02
Maximum Frequency (base frequency)
Range
【1.40~ 599.00】Hz
01-03
Maximum Frequency Voltage Ratio
Range
【0.0 ~ 100.0】%
01-04
Medium Frequency 2
Range
【1.30~599.00】Hz
01-05
Medium Frequency Voltage Ratio 2
Range
【0.0 ~ 100.0】%
01-06
Medium Frequency 1
Range
【1.30~599.00】Hz
01-07
Medium Frequency Voltage Ratio 1
Range
【0.0 ~ 100.0】%
01-08
Minimum Frequency
Range
【1.30~599.00】Hz
01-09
Minimum Frequency Voltage Ratio
Range
【0.0 ~ 100.0】%
 Maximum output frequency is set by parameter 01-02 when 01-00=【7】(Custom V/F)
 For 01-00 ≠【7】, the maximum output frequency is limited by parameter 00-12, frequency upper limit.
01-03 (Vmax)
01-05 (Vmid2)
01-07 (Vmid1)
01-09 (Vmin)
01-08 01-06 01-04 01-02
(V)%
Hz
650.00