TECO L510 - Page 86

4-52
06-Auto Run (Auto Sequencer) function
06-00
Auto Run( sequencer) mode selection
Range
0: Disable
1, 4: Execute a single cycle operation. Restart speed is based on the previous stopped speed.
2, 5: Execute continuous cycle operation. Restart speed is based on the previous cycle stop speed.
3, 6: After completion of a single cycle, the on-going operation speed is based on the speed of the
last stage. Restart speed is based on the previous stopped speed
1 to 3: After a stop the inverter will start with the incomplete step when the run command is
re-applied.
4 to 6: After a stop the inverter will start with the first step of the cycle when the run command is
re-applied.
Frequency step 0 is set by parameter 05-01 keypad Frequency.
06-01
Auto Run Mode Frequency Command 1
06-02
Auto Run Mode Frequency Command 2
06-03
Auto Run Mode Frequency Command 3
06-04
Auto Run Mode Frequency Command 4
06-05
Auto Run Mode Frequency Command 5
06-06
Auto Run Mode Frequency Command 6
06-07
Auto Run Mode Frequency Command 7
Range
【0.00 ~ 599.00】Hz
06-16
Auto_ Run Mode Running Time Setting 0
06-17
Auto_ Run Mode Running Time Setting 1
06-18
Auto_ Run Mode Running Time Setting 2
06-19
Auto_ Run Mode Running Time Setting 3
06-20
Auto_ Run Mode Running Time Setting 4
06-21
Auto_ Run Mode Running Time Setting 5
06-22
Auto_ Run Mode Running Time Setting 6
06-23
Auto_ Run Mode Running Time Setting 7
Range
【0.00 ~ 3600.0】Sec
06-32
Auto_ Run Mode Running Direction 0
06-33
Auto_ Run Mode Running Direction 1
06-34
Auto_ Run Mode Running Direction 2
06-35
Auto_ Run Mode Running Direction 3
06-36
Auto_ Run Mode Running Direction 4
06-37
Auto_ Run Mode Running Direction 5
06-38
Auto_ Run Mode Running Direction 6
06-39
Auto_ Run Mode Running Direction 7
Range
【0】: STOP 【1】: Forward 【2】: Reverse