TECO L510S Series - Page 76

4-31
00- 05
Main Frequency Command Source Selection
00- 06 Alternative Frequency Command Source Selection
Range
【0】:UP/DOWN of Keypad
【1】:Potentiometer on Keypad
【2】:External AVI Analog Signal Input
【3】:External ACI Analog Signal Input
【4】:External Up/Down Frequency Control
【5】:Communication setting Frequency
【6】:PID Output frequency
 When 00-06 =[6], frequency command source is output of the PID.
00- 07 Main and Alternative Frequency Command Modes
Range
【0】:Main Or Alternative Frequency.
【1】:Main frequency + Alternative Frequency
 When 00-07=【0】, the frequency source is set by the Main frequency parameter 00-05
(Default) or by the Alternative frequency parameter 00-06. Use any of the external terminals
S1 to S5 and set the relevant parameter 03-00 to 03-04 =【13】to switch from main to
Alternative source.
 When 00 - 07 =【1】The Frequency command will be the result of setting of Main & alternative
frequencies.
00- 08 Communication Frequency Command
Range
【0.00~599.00】Hz
 This parameter can be used to read the set frequency in communication mode
 This parameter is only effective in the communication mode.
00- 09 Frequency Command save on power down (Communication mode)
Range
【0】:Disable
【1】:Enable
 00-09=【0】 Keypad frequency is saved.
 00-09=【1】 Frequency set by communication is saved.
00-10 Initial Frequency Selection
Range
【0】:By Current Frequency Command
【1】:By Zero Frequency Command
【2】:By 00-11
00-11 Initial Frequency Set point
Range
【0.00~599.00】Hz
 This parameter is only effective in keypad mode..
 When 00-10=【0】,the initial frequency will be current frequency.
 When 00-10=【1】,the initial frequency will be 0.
 When 00-10=【2】,the initial frequency will be as set by parameter 00-11.