There are 3050 station memories for this device, with great
flexibility in memory storage. Please refer to the chart below:
1. Memory PAGE 0, noted as "P0", consists of 650 station
memories, 100 assigned for FM/MW/LW/SSB and 250 for SW.
2. Memory PAGE 1 to 24, noted as "P1", "P2" etc., each page
consists of 100 station memories, in total 2400 station
memories.
WORKING WITH STATION MEMORIES
FM
MW
LW
SW
SSB
Page 0 [P0]
100
100
100
250
100
Memory for each band (650)
Band
Memory
Each memory
page can store
100 station
memory
ATS
Memory amount all bands (2400)
Page 01-24 ATS
Note:
When viewing the stored stations in P0, it will only show the
stations of the band that was selected when entering the VM
mode. If you wish to see the stored stations from a different band,
select the band of your preference and reenter the VM mode. In
all other pages (P1 – P24), it is not necessary to preselect the
band; the device will show the stored stations from all bands.
STORING STATIONS MANUALLY
1. In VF mode, press the [FM], [AM],
[SW] button for band selection, then
tune into your desired station.
2. Press the [MEMORY] button,
"PRESET" will flash in the top right
corner of the display, then rotate the
[TUNING] button to select a memory
address.
3. Press the [MEMORY] button again to confirm or wait for about
3 seconds to automatically store the station into memory.
PAGE
PRESET
flashing
PL-880 10
To Next Page
Loading...
Need help?
General
