SW ATS:
1. Fully extend the telescopic antenna and press the SW [ ] or
[ ] button to select SW band.
2. There are two modes for ATS tuning:
Mode A: Press & hold the [ ] button to operate ATS for
stations within all meter bands;
Mode B: Press & hold the [ ] button to operate ATS only for
stations within the present meter band.
Note:
1. When using the ATS function for FM, MW/LW or SW mode A,
previously stored radio stations will be replaced automatically
by the newly found stations.
2. When using the ATS function in SW mode B, previously stored
radio stations will not be replaced; all newly found radio
stations will be stored in the blank memory addresses.
3. If there is too much interference in your surrounding, or many
mirrors or blank stations are stored during ATS operation, you
should extend the telescopic antenna to enhance FM & SW
reception, or rotate the radio for better reception of MW & LW.
You can also push the [ANT. GAIN] switch to the position
[NORMAL] or [LOCAL] to enhance the ATS function.
MEMORY PAGE SELECTION
1. Press the [FM], [MW/LW] or [SW] button for band selection,
then tune into your desired station.
2. Press the [MEMORY] button. The memory address flashes in
the upper right corner of the display.
3. Press the [- PAGE +] buttons to choose your desired memory
page, then rotate the [TUNING] knob to select your preferred
memory address. Press the [MEMORY] button again to
confirm, or wait for 3 seconds to automatically store the station
into memory.
PL-880 12
To Next Page
Loading...
Need help?
General
