Acquisition
Starting and Stopping an Acquisition
After the channels that you want to acquire are selected, use the following procedure.
1. Press the front-panel RUN/STOP button
to start the acquisition.
2. Press the RUN/STOP button again to
stop the acquisition.
3. To take a single acquisition, press the
Single button.
Using FastAcq
Fast acquis
ition mode reduces the dead time between waveform acquisitions, enabling the capture and display of transient
events such as glitches or runt pulses. Fast acquisition mode can also display waveform phenomena at an intensity that
reflects their rate-of-occurrence.
Use the following procedure:
1. Press FastAcq.
2. Find glitches, transients, or other random
events.
When you have identified an anomaly,
set the trigger system up to look for it.
(See pag
e 85, Capturing Intermittent
Anomalies.)
24 DPO7000 Series Q uick Start User Manual
To Next Page
Loading...
