Analyzing Wavef
orms
Taking Cursor Measurements
Use c ursors to taking measurements on acquired data.
1. Push Cursors.
2. Select the Cursor S ource.
3. Select a cursor type from one of the
following:
H Bars measure amplitude (typically
in volts or amperes)
V Bars measure horizontal
parameters (typically time)
Waveform and screen cursors
measure vertical and horizontal
parameters simultaneously.
Waveform cursors are attached to
the w aveform, and screen cursors
float, unattached to the waveform.
DPO7000 S eries Quick Start User Manual 55
To Next Page
Loading...
