Analyzing Wavef
orms
4. To take measure
ments between two
waveforms, selec t Waveform, and then
select the w aveform source for each
cursor.
5. Select Cursors > Cursor Position...,
and then use
the multipurpose knobs to
adjust the cursor position.
6. Read cursor measurement results in the
display.
Quick Tips
Use the Cursor Track M ode to set the cursors to move in tandem. Use the C ursor Independent mode to move the
cursors separately.
If you use the zoom graticule, you can place a cursor directly on a specific w aveform point to take precision
measur
ements.
You can
also move cursors by clicking and dragging them to a new position.
Vertic
al cursors measure the time from the trigger point to the vertical cursor.
56 DPO7000 Series Q uick Start User Manual
To Next Page
Loading...
